User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
N_SIGHT R900 User’s Manual for the Neptune Handheld System 1-1
1 Introduction
The Neptune Handheld System User’s Manual describes how to use the
following components of the Neptune handheld system to collect route
data. It also explains how to exchange route and account da
ta with the
host computer for the N_SIGHT™ R900
®
host software. Descriptions
for the following devices and procedures for using them are included in
this manual.
• CE5320 Handheld (CE5320)
• Trimble
®
Nomad
®
(Nomad)
• Neptune Field Programmer
• R900
®
Belt Clip Receiver (BCR)
This manual also describes how to maintain these devices, also referred
to as the Neptune hand
held system.
Conventions Used in this Manual
This manual uses the following icons and typographic conventions to
identify special information.
The Warning icon identifies actions that can injure the user or
permanently damage the product.
The Caution icon identifies important information that is critical to
successfully operating N_SIGHT R900.
Pilot Release