User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
N_SIGHT R900 User’s Manual for the Neptune Handheld System B-1
Appendix B Tokens List for Custom Format Screen
With the Field Programmer, tokens are constants and special characters
used as part of a ProRead format to do the following:
• Indicate a constant value
• Indicate where an inserted value, such as
reading or check sum,
goes.
The following tab
le describes tokens used on the Custom Format
screen.
Table B.1 Custom Format Tokens
Token Explanation
STX Starting character (0x02)
ETB End of text block constant (0x17)
CKS Check Sum (programming byte checksum after
eliminating tokens)
ETX End of programming frame
MRT Meter reading token (0x7B)
ID Register ID based on the selection of ID digits on
Ne
wFMT tab (1-10 digits)
NULL Null (0x
00)
Pilot Release