User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
N_SIGHT R900 User’s Manual for the Neptune Handheld System A-1
Appendix A Changing Volume Settings
Adjusting Customized Sounds
The volume of the CE5320 is actually controlled through N_SIGHT
host software and the handheld-specific settings. If you changes the
volume on the handheld, it reverts to the default setting the next time
that the unit synchronizes. The volume on the Nomad is controlled by a
scroll bar.
Changing the Volume Setting on the CE5320
To adjust the volume control setting on the CE5320, complete the
following steps.
1 On the N_SIGHT R900
Login screen, press M or
tou
ch Menu.
The N_SIGHT
R900
Main Menu screen
appears.
Figure A.1 N_SIGHT R900 Main Menu
The following instructions are for the CE5320 handheld only. To adjust the volume on
the Nomad, see
“Changing the Volume Setting on the Nomad,” on page A-5.
Pilot Release