User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Troubleshooting
10-4 N_SIGHT R900 User’s Manual for the Neptune Handheld System
Basic Tasks for the Nomad Handheld
Question Answer
The display is empty and the Nomad
does not beep when I press a key.
The Nomad can be turned of
f. Press the
I/O key to turn the
unit on.
When I press the
I/O key, the
Nomad does not turn on.
The battery can be too low. Connect the Nomad to its power. Then,
check the color of the battery indicator in the bottom right corner of
the Nomad. The indicator turns red if the battery is low.
W
ARNING: On Battery ___ % (indicating a very low battery life
remaining).
If this message appears,
place the Nomad in the cradle, and allow
it to remain until the indicator turns green, indicating that the
battery is fully charged. Recharging
the battery can take from three
to six hours.
The Nomad does not refresh when I
place it in a communication cradle.
If the battery indicator is not red, make sure that the
communication cradle is connected to a proper e
lectrical outlet.
Check that all cables are secure.
When trying to log in, I receive the
err
o
r “DB Unini
tialized.”
Check that the Reader ID is set up in the N_SIGHT R900 host
software.
Reload the handheld.
Press Synchronize to communicate with the DB.
The Nomad Handheld locks and does
not respond when I press keys.
Press .
Reset the unit. For help with this task, refer to the procedure
“Resetting the CE5320B,” on page 10-7.
Pilot Release