User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Troubleshooting
N_SIGHT R900 User’s Manual for the Neptune Handheld System 10-3
Question Answer
The display contrast is weak or the
display background is very dark.
Press
and to brighten the display.
The CE5320B handheld has been exposed to temperatures
outside the range of -30ºC to +50ºC (-22ºF to 122ºF). Short
exposure to temperatures lower or higher than these can cause
the display to turn very dark or very light until the unit returns to the
recommended operating
temperature.
The CE5320B handheld does not turn
of
f automatically or manually.
The CE5320B handheld is in a communication cradle, in which
case the CE5320B handheld remains on until you remove it from
the cradle and then turn it off.
When I try to communicate with the
host comput
er, I receive the error “Last
Sync Failed.”
I a
m unable to load or unload data to or
from the host computer
.
Make sure that you have set up the communications peripheral
you are using according to the directions provided in “Connecting
to the Host Computer and Power Supply,” on page 3-5 or
“Connecting to the Host Computer and Power Supply,” on page
4-4.
Check that all the cables are correctly attached and secure.
At the Synchronize screen (N_SIGHT R900 Login screen), confirm
that the server name is correct.
F3
Pilot Release