User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Maintaining and Repairing the Neptune Handheld System
9-22 N_SIGHT R900 User’s Manual for the Neptune Handheld System
Using the Charger
The supported lithium ion battery charger is designed to charge the
Neptune 3.7VDC 5000mAh Li-Ion battery P/N 13143-001. The
following illustration shows the supported external battery charger, sold
separately as an accessory PN: 13148-001.
Figure 9.13 External Battery Charger
To charge the battery using the external battery charger, complete the
following steps.
1 Place the charger on a flat and stable surface.
2 Connect the charger to an AC wall plug
using the AC cable deliv-
ered together with the device.
The three colors of the LED flash for about 1 second each (red –
yellow – green). After that
, the LED sequence flashes, and the
charger is ready for use.
3 Remove the charger from the wall plug if it will not be used for
long period time.
Do not try to charge any other battery with this device.
If an error is identified, the LED turns red. Immediately remove the
battery from the charger.
Pilot Release