User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Maintaining and Repairing the Neptune Handheld System
9-10 N_SIGHT R900 User’s Manual for the Neptune Handheld System
To install a new battery, use the following procedure.
1 Fold the foam flap back and remove th
e old battery.
2 Position the new battery over the compartment so that the
label of
the battery faces down and the arrow ( ) on the top of the battery
points to the right.
3 Lower the left side of the battery — the side that is across from the
arrow ( ) — into the battery compartment.
4 Then, lower th
e rest of the battery into the compartment, pushing
firmly until th
e battery is fully seated as shown in Figure 9.7.
Figure 9.7 Inserting the Battery
5 Fold the protective foam flap over the battery and replace the door
of the battery compartment.
6 Secure the door of the battery compartment to the back panel of the
CE5320 by turning each of the four captive screws clockwise until
you
feel some resistance.
Because the CE5320 uses captive screws, you cannot remove the screws,
but can only loosen them until they detach from the back panel.
Pilot Release