User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Using the Field Programmer
N_SIGHT R900 User’s Manual for the Neptune Handheld System 8-47
3 Touch NewFMT.
The New Format screen
appears as illustrated in
Figure 8.38
on page 8-41.
4 Touch since the
NewFMT screen now
defaults to New to select
an existing format name.
See Figure 8.39 on page
8-43.
5 Touch .
The New Format screen
appears with the fields and
selections empt
y.
Figure 8.41 Gas New Format Screen – Blank
6 Type the name of the new format in Format Name.
7 Complete information for the following items, where applicable.
• Multipli
er
• Input
•PCF See “Pressure Configuration Factor Indexes,” on page C-
1. Contact the meter manufacturer if you have any questions.
• DispDigits
• Initial Reading
• Rotation (see Table 7.6 on page 8-45.)
8 Touch .
A dialog appears asking you to enter a different name for the
fo
rmat.
9 Tou
ch or click Yes to save the changes to the new format or No to
cancel.
1
0 Type the name of the new format in Format Name.
Pilot Release