User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Using the Field Programmer
N_SIGHT R900 User’s Manual for the Neptune Handheld System 8-23
Using Command Gas
The Command Gas tab allows you to perform the following functions at
any time you are using the Field Programmer for gas functionality.
• Refr
esh the data for the R900G endpoint.
• Place the R900G endpoint in Sleep mod
e.
• Wake up the R900G endp
oint
from sleep mode.
• Close the Program Gas screen an
d return to the start screen.
To use Command Gas, complete the following instructions.
1 Start the Neptune Field Programmer software; refer to “Starting
Field Programmer,” on page 8-6.
2 Select Program Gas
from the
Field Programmer
Menu.
3 Select Command.
The Command
Gas
screen appears as
illustrated in Figure 8.25.
Figure 8.25 Command Gas Screen
In order to perform these commands, align the mouse with the unit.
Pilot Release