User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Using the Field Programmer
8-20 N_SIGHT R900 User’s Manual for the Neptune Handheld System
3 Touch or click the format you want and press Enter.
4 For Initial Reading, type a value.
5 Align the
IR LED to Gas Programming post, and do one of the fol-
lowing to program gas:
• Press the program button on the mouse
• Press Enter.
• Touch or click .
(This button can only be used for programming; it cannot be
used for Read or
Query.)
The Program Result area of the
screen dis
plays that it is
Confirming Data, and a
progress
bar at the bottom of
the screen shows you the
progress. See Figure 8.21.
Figure 8.21 Program Result – Sending Data
An audible tone signals
the Program Result.
•PASS
•FA
IL
The MIU ID displays the
ID or serial number of the
MIU. See Figu
re 8.22.
Figure 8.22 Program Result – Pass Screen
Pilot Release