User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Using the Field Programmer
8-18 N_SIGHT R900 User’s Manual for the Neptune Handheld System
Programming the R900G Endpoint
You need to configure the gas functionality in the Field Programmer
software after the installation.
Configuring Gas
To program the R900G endpoint, use Neptune’s N_SIGHT R900 and
complete the following steps.
1 Select Configure Gas
from the
Field Programmer
Menu. See “S
tarting
Field Programmer,” on
page 8-6.
2 When prompted, enter
you
r password. See
Figure 8.6 o
n page 8-7.
The Gas Preferences
screen appears as
illustrated in Figure 8.18.
Figure 8.18 Gas Meter Configuration Screen
3 Select one of the following for receiving a confirmation.
• OFF – to turn off some confirmation dialogs for actions.
• ON – to allo
w all confirmat
ion dialogs for actions.
4 Touch to return to the Field Programmer Menu.
Pilot Release