User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Communicating with the Host Computer
N_SIGHT R900 User’s Manual for the Neptune Handheld System 7-5
1 Do one of the following.
• Place the CE5320B handheld in the cradle by sliding it bottom
first into th
e cradle.
• Place the Nomad handheld into the Charging/Communications
Cradle or connect the Nomad to th
e PC with the USB Cable.
2 On the N_SIGHT
R900 Login screen,
press or touch
Synchronize.
Figure 7.5 Synchronize Button
If your handheld system is set to AutoSync, the handheld will
indicate with the audible message "Connected" when it is starting
the communications process.
When the handheld is removed from the Cradle, it will indicate
with the audible message "Disconnected" (regardless of sync
mode).
The hour glass appears on the screen to show that the
communications process in underway.
Touch Synchronize to start communications. An X
appears until Network Connection is established
Pilot Release