User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Communicating with the Host Computer
7-4 N_SIGHT R900 User’s Manual for the Neptune Handheld System
6 Touch the in Change Hold Status to select one of the following
options, if applicable.
All of these hold functions determine which accounts are left in the
handheld after the route i
s uploaded.
7 Select the route to hold, if applicable.
8 Touch .
The N_SIGHT R900
Login screen appears as
illustrated in Figure 7.4.
Figure 7.4 N_SIGHT R900 Login Screen
Sending and Receiving
When ready to communicate or synchronize with the host computer, use
this procedure to send and receive information. Follow this procedure
for each handheld that you are using.
None Hold none of the accounts in the handheld.
Unread/Skipped Hold all unread accounts and all skipped
acco
unts in the handheld.
Unread Hold only the unread accounts in the handheld.
Pilot Release