User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Gathering Route Data
6-20 N_SIGHT R900 User’s Manual for the Neptune Handheld System
7 Touch one of the following to begin your search.
• Search> if you want t
o search forward in the route
• <Search is you want to search backward in the route
If only one exact match to your entered search criteria is foun
d, it is
disp
layed. If multiple accounts match your entered criteria, they
will appear in a list form. You should browse the list and select the
desired account.
Validating Readings
If the audit feature has been set on the host computer, the handheld
validates each reading you enter against the high/low range selected for
the audit feature.
Hi/Low Fails
If the reading falls within the high/low range, the handheld accepts the
reading and advances to the next meter in the route. If the reading is
outside the high/low range, the handheld does not accept the reading
and the Hi /Lo/No/Inact Check screen appears. Use this procedure to
complete a reading that falls outside the high/low range.
1 On the reading entry
screen, enter the
reading that falls
outside the high/low
range. See Figure
6.22.
Figure 6.22 Reading Outside High/Low Range
Pilot Release