User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Setting Up the R900 Belt Clip Receiver
N_SIGHT R900 User’s Manual for the Neptune Handheld System 5-11
The R900 Belt Clip Receiver Status screen now displays the device
details.
• If you have previously paired a device, go to the R900 BCR
Status screen and not the AMR
Connection screen.
• If you want to Change De
vices, you can click this option on
the bottom of the R900 BCR Status screen.
You then see the AMR Connection screen and can choose the
dev
ice from the drop
-down selection list.
Using the R900 Belt Clip Receiver to Read a Route
To begin reading a route using the R900 BCR, you first need to load a
route to the Nomad. See “Loading and Unloading Data for Handhelds”
in the N_SIGHT™ R900
®
Online Help.
Once the route is loaded and the pairing is complete, you can log in and
the unit can receive readings from the R900 BCR.
R900 Belt Clip Receiver Status Screen in N_SIGHT R900
While the Nomad and the
R900 BCR are paired, you
can access a screen showing
the status of the R900 BCR.
Y
ou can see a message like
the one illustrated in Figure
5.3.
Figure 5.3 R900 Belt Clip Receiver Status Screen
Click to load a route when you are working in the N_SIGHT
R900 host software.Press F1 to see the instructions for loading a route to a handheld.
Pilot Release