User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Setting Up the R900 Belt Clip Receiver
5-4 N_SIGHT R900 User’s Manual for the Neptune Handheld System
Using the R900 Belt Clip Receiver
The following section explains how to use the R900 BCR.
Understanding the R900 Belt Clip Receiver Modes
The following tables describe the R900 BCR modes of operation. You
change modes on the R900 BCR with a combination of the Mode and
Enter buttons. To cycle through available modes, you press the Mode
button. The Mode indicator will flash with the color for the mode to
enter. To enter the Mode, you press the Enter button within two seconds
of pressing the Mode button. If entered, the Mode indicator displays the
newly-entered mode. If you do not press Enter within two seconds, the
R900 BCR stays in the previous mode. This combination of Mode and
the Enter button is done to prevent accidental mode changes during
operation.
Table 5.1 R900 Belt Clip Receiver Power
Function Explanation
Power ON
Press for two seconds. The backlight turns
orange when the power is applied.
The unit takes approximately one minute to fully
boot. The Mode and RF lights a
re white during
most of boot-up. The unit is fully booted when the
Mode and
Enter light turn off and the Mode LED
displays the previous mode of operation
Power OFF
Press for two seconds.The mode and RF
lights blink until off.
Setting Date/Time The R900 BCR synchronizes the time with the
Nomad when the two are paired. The time on the
R900 BC
R defaults to the time from the last
Nomad synchronization.
Pilot Release