User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Using the Nomad Handheld
N_SIGHT R900 User’s Manual for the Neptune Handheld System 4-7
Configuring the Nomad Handheld
On the Host Computer
1 On the host computer, click Start.
2Type CMD and press Enter.
A DOS window appears.
3Type ipconfig and press Enter.
4 Write the IP address here: _____________________________
5Type exit and press Enter to close the DOS window.
On the Nomad Handheld
1On the N_SIGHT R900 Login screen, press M or touch .
The N_SIGHT R900 Main Menu screen appears.
Figure 4.5 N_SIGHT R900 Main Menu
Before proceeding with this section, you must complete the information for the
handhelds in two tables within the N_SIGHT R900 host software: Handhelds
and Reader ID. Refer to the N_SIGHT R900 Online HTML Help for the steps
to complete this information in these tables.
Pilot Release