User's Manual

128 NeoPoint™ 1600 User’s Guide

On Your PC/Laptop:

NOTE:Ensure your baud rate/bits per seconds is set to 19200 for

receiving data.

1. Type one of the following AT commands:

• ats0=x (where x = 1, 2, etc.) to automatically answer the incoming call

• ata when receiving a ring message to manually answer the incoming call

2. File transfer can begin when the message CONNECT is displayed.

Sending a Data File

NOTE:Your NeoPoint does not require that you change to Incoming

mode - ensure that Incoming Mode is set to Voice.

Use your modem program to initiate data call.

For example, to manually make a data call type atd follow by the phone number, e.g.,

atd2225558888.

When a call is established, a message stating CONNECT is displayed on the terminal.

File transferring can now begin.

Select the name of data file where it is stored and the protocol that you want to send

the file.