User's Manual

116 NeoPoint™ 1600 User’s Guide
A
Setting Up Your NeoPoint to Receive and Send a
Fax
There are three sections for using your NeoPoint phone as a modem to send/receive a
fax:
• Using WinFax Pro 9.0
• Using HotFax 3.01
• Using Other Fax Programs
Each section describing a specific fax program includes:
• Setup Procedures
• Receiving a Fax
• Sending a Fax
Using WinFax Pro 9.0
Setup Procedures
1. Ensure that your NeoPoint phone is connected to your PC and is powered ON.
2. Open WinFax Pro.
NOTE:If you are unsure about setting up WinFax, refer to your
WinFax documentation for specific instructions.
3. From the Tools pull-down menu, select the Setup command. The WinFax Pro
Program Setup window will appear.
4. Select Modems and Other Fax Devices.
5. Click on PROPERTIES.
If your NeoPoint modem has not been setup or is not in the Connective Device
list, you need to add it to the list. If it is setup - indicated by a check mark
(active), skip to step 19.
6. Click on ADD... to install your NeoPoint modem. The Install New Modem Type
window will appear.
7. Select Regular Modem as modem type and click on NEXT.
8. Click on NEXT and the system will attempt to detect your phone as a modem.