User Manual

102 NeoPoint 1600 User’s Guide

You are now ready to use Dial-Up Networking to access remote servers with your

NeoPoint 1600 phone.

Using Your NeoPoint to Receive/Send a Fax

The following section provides information required for setting up your fax program

and using your NeoPoint phone as a modem to send/receive a fax. Refer to your fax

program documentation for specific set up instructions.

Verify the following modem properties when setting up your fax program.

• Baud Rate: 19200 bps (default)

• Data Bits: 8

• Stop Bits: 1

• Parity: None

• Flow Control: Hardware (RTS/CTS)

Receiving a Fax

1. Ensure that your NeoPoint phone is connected to your PC and is powered ON.

2. Once the Main screen is displayed on your NeoPoint phone, press and release

the POWER ON/OFF key to go to Quick Mode.

3. Using the NAVIGATOR key, scroll to Incoming.

4. Set Incoming mode to Fax In.

NOTE:Once you have set your NeoPoint phone Incoming Mode to

Fax In, you cannot receive regular voice or data calls until you

change Incoming Mode back to Voice.

5. In your PC’s fax program, you need to setup the Answer mode. Click on

RECEIVE and select one of the following:

Automatic Receive (recommended)

Manual Receive

Your NeoPoint modem is now ready for receiving an incoming fax.

Sending a Fax

NOTE:Your NeoPoint does not require that you change to Incoming

mode - ensure that Incoming Mode is set to Voice.

To send a fax, refer to your fax program documentation for specific faxing

instructions.