{ham pe reach sty MANUAL es ar rage pe ay GATE AAA Or DOr PINEY GBC bY NOOK FH DN of char than in ws rar. ERT EA caution ee A INSTRUCT Eel ea Re en Tina een ont ot cove ace Po cow rare 1 Em eek ml oe am ope i mie SET 2 min Stewart mre SERVIETTES AV &TITMOUSE ia IE A Attention mrt sat, run vm disdain ddr oP.) ot Fen, Core cones cs Roman sen ont orange Qe wie chore poet ter Dm chm ped ope rie rm er kr, aon ire I earn 1 Fa Gore Cope Baker rae.
For positioning the HA products: Noninterchangeable of arm. Wall mount assembly— Cable Replace the arm covers Adjusting universal joint tension-Before starting Assembly Please pond some time reading this Installation guide then follow the simple step by step guide fo assembly. * Some panels are viewed differently from the exploded drawing below, this Is for extra clarity. + Do not discard any of the packaging until you have checked all the parts and the pack of fittings.
Joint tightness adjustment NS Ro Tighten 180° P = Loosen Right view Unit:mm Son RE wal 513 64 1 504 1164~1354 600
Top view 2200 1100 Note lase level gauge or protractor to help the wall mount Installation. Untimely If the wall box .
Step 1.1 1. Make sure the substantial wall before assembling. 2. Place the wall mount on the preferred place and height and mark the 4 points. 3. Install the wall mount on the wall with 4 expansion bolts. Recommended drill bit size: diameter 8mm / depth 4. Hide the screws with the cover. Tighten) else love gauge to help the wall mount Installation. Dolls RC wall Recommended drill bit size: diameter @8mm / depth 40 £2 mm Step 1.2 Place the arm onto the spindle.
Note Note: Please make sure this joint is in vertical 90 degree. Solid RC.
Step 1.1 Remove cable covers. Slid the cable cover out of the arm slot carefully as shown. #Remove the VASE cable cover by the screw driver (not provided) as shown in figure.Keep the screws for re-screwing. Step 1.2 Insert cables through arm. Cable Wrapper assembly If the cables are needed to go through the underside of VASE, use the screw driver to take off the cover. «The VASE adapter must be moved fully down for putting the cable through.
Step 1.1 Fix the Monitor on the VASE mount using screw driver (not provided) and screws. VASE Mount adjustment: Caution for weight capacity adjustment: 1.Make sure you have checked out the weight of the panel you wish to mount . support the arm throughout/during assembly. Adjustment: Use the Allen key provided to adjust the weight capacity. Twist the Allen key In a clockwise direction for more weight: counterclockwise direction for less weight. Loading: 1~3 kg.
Step 1.1 as shown. Step 1.2 } Follow the order as below to assemble the covers. Replace the adjuster covers Press the gas spring Step 1.3 Follow the order as below to assemble the covers. Replace the adjuster covers as shown.
Step 1.4 Follow the order as below to assemble the covers. Replace the VASE covers as shown. When assembling the am with monitors of different weights, you may find that the tension of the universal joint needs fo be adjusted to ease movement or fo maintain the desired monitor potion. If so, adjust as follows: a. Remove the plastic universal joint cover. b. Find the screw head and use the provided Allen key fo adjust the tension. ¢.
