User's Manual

For after-sales support, questions, information and the full text of
the warranty, go to: www.moleskine.com/support
제품 구매 후 지원, 제품정보, 제품보증사항은 www.moleskine.com/support
를 참조하십시오.
LED Colour Status Information Precautions
Product Warranty
Serial No. /
제품번호
Date of Purchase /
구입일자
Seller /
구입처
FCC Information to User
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
·· Reorient or relocate the receiving antenna.
·· Increase the separation between the equipment and receiver.
·· Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
·· Consult the dealer or an experienced radio/TV technician for help.
IMPORTANT NOTE : FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 0.5 centimeters between the
radiator and your body. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
IC Information to User
This device complies with Industry Canada’s licence-exempt RSSs. Operation
is subject to the following two conditions:
(1) This device may not cause interference; and (2) This device must accept
any interference, including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes :(1) l’appareil ne doit pas produire
de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, meme si le brouillage est susceptible d’en compromettre
le fonctionnement.
Attention: Tout changement ou modi_cation non expressément approuvé
par le fabricant peut annuler le droit de l'utilisateur à utiliser l'équipement.
exposition aux rayonnements radiofréquences. Pour se conformer aux
exigences de conformité de l'exposition IC RF, une distance de séparation
d'au moins 0.5 cm doit être maintenue entre l'antenne de cet appareil
et toutes les personnes.
Caution
THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS
NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE. SUCH
MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
과학기술정보통신부 고지에 따른 고지사항
· ·
해당 무선설비는 운용 중 전파 혼선 가능성이 있으므로 인명 안전과 관련된 서비스는 할 수 없습니다.
· ·
이 기기는 가정용(B급) 전자파 적합기기로서 주로 가정에서 사용하는 것을 목적으로 하며,
모든 지역에서 사용할 수 있습니다.
Regulatory Compliance Information
LED 표시 안내 주의
규정 준수 정보
제품 보증
Status
상태
LED colour
LED 컬러
Power ON
전원 ON
App connection
앱과 연결 시
Low battery power
배터리 부족
Sensor recognition or
usage environment check
인식센서 또는 사용환경 점검 필요
KC:R-C-NCV-NWP-F130
203 -JN1196
FCC ID: 2AALG-NWP-F130 IC: 21452-NWPF130
Product Specification
Model Name
Wireless Connection
Receiving / Transmitting Frequency
Tx Power
Storage Media
Battery
Charging Time
Rated Input
Usage Time
Size and Weight
Usage Environment
Ink refills
NWP-F130
Bluetooth® 4.2 (LE)
2,402 ~ 2,480 MHz
≤ 1mW (0 dBm)
16MB of internal memory
Rechargeable Lithium Polymer Battery 3.7V / 180mAh
About 90 min
DC 5V / 1A
Max 125 days in standby mode
Standard mode: 8 hours(for continuous writing)
Eco mode: 11 hours(for continuous writing)
* Actual usage time may vary depending on usage environment.
Length: 143 mm /5.6" (without pen cap)
Thickness: 12.4 Φ / 0.49" (without pen cap)
Weight: 15.8g / 0.56 oz (without pen cap)
Operating temperature : 10 ~ 35 °C / 50 ~ 95 °F
Temperature for storage(No operation) : -10 ~ 50 °C / 14 ~ 122 °F
Relative humidity : ~ 90%
D1 multi pen ink refills