Owner Manual

Installation Diagram
Tile or stone material
Tile adhesive or thinset
Pea gravel or tile spacer
Sloped mortar bed 2
Waterproof membrane
Sloped mortar bed 1
Concrete/Masonry/XPS board/
Cement mortar bed
2" drainage pipe
Ply wood
Silicone or grout
Grate
Outlet
PVC/ABS drain base /sub drain
(Not include, purchase separately.)
Building paper
Clamping plate
Rubber gasket /
Threaded coupling
Install with drain base
4
2" or 3" schedule 40 DWV pipe
1. Rubber Coupling / Gasket
2. Threaded coupling
3. Membrane clamp
4. Stainless steel bolts
5. Drain flange/Drain base.
6. Waterproof membrane (not include)
Drain base assembly
(Not include, purchase separately)
2" OD outlet
1.
2.
Fit for different situation
© Jun 2021 Haizi Sanitary Ware Co.,Ltd.
All reasonable care have been taken in compiling the information in this document. All recommendations and suggestions
on the use of Neodrain products are without guarantee since the conditions of use are beyond the control the Company. It
is the customer’s responsibility to ensure that each product is fit for its intended purpose and that the actual conditions of
use are suitable. Neodrain Technologies Co.Ltd reserves the right to change products and specification without notice.
Please be sure to read carefully before installation.
www.neodrain.com
Note:
Solvent-weld (glue) to same material DWV pipe
with correct solvent cement.
The PVC drain base made of plastic, do not work
with Hot-mop waterproofing.
Mortar bed 2 plus tile and adhesive should be not
less than 1-1/2"(40mm)
Consider the drain base diameter when you install
the drain against the wall .