Owner Manual

3
4
8
1
0
7
1
°
sl
ope
Dustcloth
2
Side View
SUB FLOOR
SUB FLOOR
Slope
2
MORTAR
6
Installation
The following installation details do not cover every possible situation, some may not be appropriate for DIY. Always consult with
licenced professional during installation.
Installation Step:
1. Coupling the drain base outlet to 2" or 3" schedule 40 DWV pipe using correct solvent cement.
2. Block the drain opening with rag. Trowel mortar to build shower pan, reinforce around drain base to be flush with the floor,
grade to create MIN 1% slope towards the drain.
3. Lay the waterproof membrane on whole shower pan, cut a slit for the bolts to poke through, then cut away the waste hole in
the center. Bond the membrane around the waste hole with waterproof silicone.
4. Install the coupling plate, fasten the bolts. Perform leak testing be required before next step.
5. Push the drain outlet into the waste hole. Spread pea gravel or tile spacer around the drain base to protect the weep holes.
Weep protector also be available.
6. Adjust drain body perpendicular to the slope direction, the top edge need to be flush with the height of tile surface, then
level the drain body. (12" and less size can be adjusted and leveled without leveling feet.)
7. Trowel mortar onto the membrane, build up the shower floor allowing for thickness of tile and adhesive, grade to create
MIN 1% slope towards the drain.
8. After the floor mortar has cured, install the floor tile with tile adhesive or thin set mortar, using notched trowel.
9. Fill the gap around the drain body with silicone bead or grout, sweep off the excess material.
10. Take away the protective fabric, finalize the installation by laying the grate into the channel.
Care & Maintenance
3
After installation, some aggressive substance such as sealant, adhesive, mortar maybe cause on the channel, "yellow spot"
recommend using scour pad to remove such spot" ",and always brushing in the direction of the gain. Periodically clean the fixture
with non-abrasive cleaner or soft scrub.
For polished, matte black and oil rubber bronze finishes, we recommend cleaning with mild soap and soft cloth. DO NOT USE
abrasive cleaners, ammoniated products, rubbing alcohol, detergents, astringents, bleach based cleaners, aggressive
chemicals, abrasive cleaning pad, or harsh polishes on the fixture. Use of such substance may void the warranty.
Please be sure to read carefully before installation.