User's Guide

neo.cortec
.
Page 8 of 10
Document version 1.4
8.1.2 End user manual
8.2 European Union - CE
8.1.1 FCC Labeling requirements
The NC1000C-9 modules have been labeled with their own FCC ID number. Since the number is lo-
cated on the bottom side and therefor not visible, it is needed to place a label on the outside of the
finished product into which the module is installed referring to the enclosed module. This exterior
label can use wording such as the following:
The OEM integrator shall not provide information to the end user regarding how to install or remove
this RF module in the user's manual of the finished product containing this module.
The manual of the finished product shall include all required regulatory information as shown in the
FCC Notice in this manual.
The NC1000C-8 module has been certified for use in the European Union. The device has been te-
sted to comply with the following standards:
• EN 300 220-2 V3.1.1
• EN 301 489-1 V2.2.0
• EN 301 489-3 V2.1.1
• EN 62479:2010
• EN 62368-1: 2014
Contains Transmitter Module FCC ID: 2AB76NC1000C1
-or-
Contains FCC ID: 2AB76NC1000C1
This device complies with Part 15 of the FCC Rules. Operation is subject to the follow-
ing two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.