User's Guide

- 27 of 42 –
neo.
cortec
.
3.4.1.8 AAPI Wakeup time
ID: 52
Specifies the time from which the nWU pin transitions active (low) until the module starts
to send data to the host controller. This value shall be set such that the external host has
enough time to receive data, when waking up from the nWU active event.
Possible values are 1…255, where 16 is default. The Wakeup time parameter is in steps
of 30.5uS. The default value (16) corresponds to 488uS.
3.4.2 RF settings
3.4.2.1 TX Output Power
ID: 33
The RF transmitter output power. Possible values depend on the module version.
3.4.2.2 FHSS Channel Mapping
ID: 41
The frequency hopping channels can be configured freely to a range of RF Frequencies.
16 logical channels can be mapped to a range of RF Frequencies.
Resolution as well as highest and lowest frequencies depends on the frequency band
and module version. The possible frequencies are also limited by regulatory
requirements. The configuration tool limits the possible frequencies in accordance with
the ETSI (2.4GHz, 868MHz & 433MHz) and FCC (2.4GHz & 915MHz) rules. For other
regions, there may be other rules which needs to be observed when allocating the
channels.
Channel 1 though Channel 15 is used for Scheduled Data transmissions. The hopping
sequence is 1,2,3,4,5,6,7,8,9,10,11,12,13,14,15. If a pseudo random hopping sequence
is desired, the mapping must be done accordingly.
Channel 16 is used for Beacon transmissions. Channel 17 is used for WES. Channel 18 is
used for Wake beacons.
3.4.3 Network access and address settings
3.4.3.1 Node ID
ID: 10
Specifies the Node ID of the node. Legal values are 0x0001 to 0xFFEF. Nodes in the
range 0x0001 … 0x007F are sink nodes, and can be directly addressed by other nodes
in the network.