User's Manual
Poids de l’Appareil
856 grammes
Alimentation de Sortie
RMS 16W (8 Watts
x 2 haut-parleurs/4 ohms)
Rapport Signal/Bruit
88dB +/- 3dB
Source d’Alimentation
Batterie de 2800 mAh au
Lithium-ion, 3.7 V
Entrée USB / Sortie USB
5V, 1A
Gamme de Fréquences
125Hz-18000Hz
Bluetooth
Bluetooth® CSR 4.1
Durée d’Utilisation
+ de 12heures avec une
charge complète et un
niveau de volume à 75%
Point de Fixation
Pour Monture
Diamètre 6mm
Options de Chargement
Adaptateur USB connecté
au secteur ou à l’ordinateur
Durée de Chargement
Environ 3heures
Température de Stockage
de la Batterie
15°C
Température de
Fonctionnement
-5°C à 40°C
Certification Militaire
des Etats-Unis
MIL-STD 810G
Facteur d’Étanchéité
IP68
Dimension de l’Appareil
231 mm
107 mm
79 mm
Point de Fixation Pour Monture
Caractéristiques
Turn on Bluetooth on your Bluetooth device (Smart Device)
and set the device in pairing mode. Available Bluetooth
connections shall appear. Select the ECOXGEAR speaker
from the list of discovered devices on your Bluetooth
device. Wait for a few seconds until the connection is
completed.
NOTE: Bluetooth connection feature is found in the
Settings section of most mobile phones and other
Bluetooth enabled devices.
When the ECOXGEAR selection is made and the
Bluetooth connection is completed, your EcoCarbon will
announce: “Bluetooth connected”
Once connected, select and play your desired audio.
PAIRING MODE: If the LED is not flashing or if you wish to
place your EcoCarbon in pairing mode, press and release
the Bluetooth button on the top panel. Your EcoCarbon
shall announce “pairing ready” when ready to pair to a new
device.
NOTE: Your EcoCarbon shall sync & wirelessly pair with
most Bluetooth enabled devices. The unit remembers
the last device paired and will automatically search for
previous connections when the speaker is turned on or
when a device comes back into Bluetooth range. If a
connection is lost due to range, the speaker will look to
re-establish that connection. If Bluetooth is turned off on
your Smart Device, the EcoCarbon may not automatically
look for the device.
RECOMMENDATION: If you are not familiar with
Bluetooth pairing for your Smartphone or other Smart
Device, refer to the User Guide for your Smartphone to
learn how to add and pair a new device (EcoCarbon for
instance) to your Smartphone using Bluetooth.
BLUETOOTH PAIRING & CONNECTIONS: Once paired,
should you have an issue switching between Bluetooth
connections between devices, open the Bluetooth Section
within the device currently connected to the EcoCarbon
and delete the Bluetooth connection. The EcoCarbon
will then be available to pair & connect to an alternate
Bluetooth enabled Smartphone / Audio Device.