User's Manual

1
2
3
Charge Your EcoCarbon
Before you power on your EcoCarbon connect the USB
Micro port to the USB cable and a power source to fully
charge your EcoCarbon for best performance.
NOTE: Before using your EcoCarbon for the first time,
charge the unit until all 4 LED battery level indicators on
the front are solid green, indicating a full charge.
Approximately 3 hours of charging is required from a low
to a full charge.
Power source options include the USB connection to
your computer or a power outlet using a USB to AC
power adapter. It is recommended to always use the
USB cable included with your EcoCarbon.
Bluetooth Pairing & Your Audio
Connecting With Bluetooth:
Connect To Your Smart Device & Play Audio
When your EcoCarbon is turned on, the blue LED light
on the top panel will flash rapidly indicating the unit is
ready to pair.
Power On, Battery, & LED Status Indicators
Once fully charged, press the Standby Power Button
on the top of your EcoCarbon. You will see the green
LED light & you will hear an ascending bell tone when
powering on.
IMPORTANT: Make sure that the Main Power Switch,
located in the back compartment under the cap, is set in
the Upper ON position. If the switch is in the Lower OFF
position, your EcoCarbon will not be able to turn on using
the Standby Button.
The LED battery level indicators are located on the front
of the unit. Each bar represents 25% of a charge, with 4
full LEDs indicating a full charge.
Audio playback time over Bluetooth connection is
approximately 12 hours at 75% volume.
Set Up Recommendations 1-2-3
Câble USB
Pour Recharger
Adapteur secteur (5V, 1A) - USB
Adapteur pour allume-cigar AC (5V, 1A) - USB
Pour le Montage
Support Ventouse (6mm montage)
Support Guidon (6mm montage)
Guide d’UtilisationAppareil Bluetooth
EcoCarbon
Mousqueton Avec Clip
Guide d’Utilisation
Models: GDI-EXCBN200...209
EcoCarbon
Accessoires en Option