User's Manual

4 / 4
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may
cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
The ECOSTONE module is designed to comply with the FCC statement. FCC ID is
WYHFW3817-40. The host system using ECOSTONE, should have label indicated
FCC ID WYHFW3817-40.
This radio module must not be installed to co-locate and operating simultaneously with
other radios in host system, additional testing and equipment authorization may be
required to operating simultaneously with other radio.
This bluetooth module has a RF port for bluetooth signal input and output, the OEM or
integrator can design the actual antenna types as required. While This module has no
shielding, and therefore the host equipment shall add a shielding funciton, and any
host with module installed, has to be retested, then additional equipment authorization
shall be achieved on the host equipment that has the module installed.