Safety Instructions
Table Of Contents
Remote Control Function
o Remove the plastic battery isolation tag from the remote control by pulling it out.
(see below picture B)
o Point the remote control towards the IR Receiver on the Controller box. (see below
picture C). Do not have the IR Receiver point directly towards strong sunlight.
o The remote control need to be in line of sight to a maximum of around 10ft from
the IR Receiver.
Use the OFF/ON buttons to turn the Light Strip ON or OFF. (see below picture B)
o Press the R, G, B or W buttons to select Red Green, Blue or White.
o Press the 16 colour selection buttons to switch between colors.
o Press the 2 Brightness buttons to increase or decrease the brightness of the
LED’s
o Switch between 4 functions with the Flash, Strobe, Fade and Smooth button.
Page 3
HOW TO INSTALL ROPE LIGHT
The design of rope light follows the principle of user-friendly and customized.
install it in different smooth surface, such as wood, plastic, metal and porcelain, etc. It can
be design and apply in different shape, easy to connect.
A. Face up lighting part when install clips.
B. Check all accessories are in properly installation before plug to electricity.
C. Bend only back, do not bend from side.
D. Fix mounting clips with nails or screws onto support surfaces. (Figure 1ǃ 2ǃ 3)
E. On a clean smooth surface, use suction cup to mount. (Figure 4)
F. Mounting clips, suction cup should be evenly spaced and both be a maximum of 1M
apart.( Figure 5)
G. Make sure that the distance between two lines of lighting chains should be at least
12mm.
Figure 1 Figure 2 Figure 3 Figure 4
Figure 5
Picture B
plasc baery
isolaon tag