Safety Instructions

Page 2
HOW TO INSTALL ROPE LIGHT
The design of rope light follows the principle of user-friendly and customized.
install it in different smooth surface, such as wood, plastic, metal and porcelain, etc. It can
be design and apply in different shape, easy to connect.
A. Face up lighting part when install clips.
B. Check all accessories are in properly installation before plug to electricity.
C. Bend only back, do not bend from side.
D. Fix mounting clips with nails or screws onto support surfaces. (Figure 1ǃ 2ǃ 3)
E. On a clean smooth surface, use suction cup to mount. (Figure 4)
F. Mounting clips, suction cup should be evenly spaced and both be a maximum of 1M
apart.( Figure 5)
G. Make sure that the distance between two lines of lighting chains should be at least
12mm.
Figure 1 Figure 2 Figure 3 Figure 4

Figure 5
CAUTION: a) DO NOT EXCEED THE MAXIMUM NUMBER OF EXTENSIONS OR FLEXIBLE
LIGHT LENGTHS PERMITTED BY THE MARKING. b) All units must be unplugged
before adding additional segment. c) Maximum total extension length:
’. Ensure all
connections and the end cap on the last segment are tightly secured to keep water from
entering. Use only extension segments recommended by the manufacturer of this system.
WARNING-Risk of fire and electric shock, uncoil flexible light
prior to plugging into receptacle.
SAVE THESE INSTRUCTIONS
WARNING
: When using “outdoor” use portable lighting products,
basic safety precautions should always be followed to reduce the
risk of fire, electric shock, and personal injury, including the
following:
READ ALL INSTRUCTIONS
(a) Ground Fault Circuit Interrupter (GFCI) protection should be provided on the circuits or
outlet to be used for the outdoor use flexible lighting product. Receptacles are available
having built-in GFCI protection for this measure of safety.
(b) Use only outdoor extension cords, such as type SW, SOW, STW, STOW, SJW, SJOW,
SJTW, or SJTOW. This designation is marked on the wire of the extension cord.
(c) Do not install closer than 3 meters from a swimming pool surface.
HOW TO REPLACE THE FUSE:
This plug contains an electrical fuse a safety feature.
• Disconnect power before replacing the fuse.
• Grasp plug and remove from the receptacle or other outlet device.
• Do not unplug by pulling on the cord.
• Slide open by unscrew the fuse access cover on top of attachment plug.
• Remove old fuse carefully.
• Never attempt to replace the fuse with a higher watt fuse.
Use only 5 A, 125 V fuse. Failure to do so may be a fire hazard.
• Set new fuse in holder and reinstall access cover.
fuse
cover