User Manual

USER MANUAL
V1.0
12V DC
Connect the included AC adapter (12V DC, 0.5A, center positive) here. Always connect all other cords
before plugging in the AC adapter. The Mini Vent II can not be powered by batteries.
IN
This jack accepts mono guitar, organ and keyboard signals.
OUT L , OUT R / MONO
The mini Vent II provides a stereo output. If you just need a mono signal the R / MONO output
delivers the best quality, particularly in STOP mode.
A-B
Switches between two programmable settings of the mini Vent II. See > Programming.
BYPASS
Turns the rotary effect on and off. When the red LED lights up, the effect is active, when it’s off the
signal is relayed to both outputs via a true bypass circuit. The last bypass state is memorized and will
be recalled on next power up.
SLOW / FAST
Switches the rotors to slow ( Chorale) or fast (Tremolo) speed. The yellow LO and red HI LED indicate
the current speed of the virtual rotors.
STOP
Pressing both the Bypass and Slow/Fast switch at once causes the rotors to stop.
The rotors always stop in the front position. By pressing Bypass and Slow/Fast again the mini Vent II
returns to the previous selected speed, while pressing Slow/Fast always selects slow speed.
Programming
Several internal parameters can be changed to your own taste. The settings can be stored to either
switch position A or B. Settings are stored to flash memory so that there's no reprogramming
necessary on next power up.
1. Power up the mini Vent II while holding the Slow/Fast switch for at least 3 seconds
This enters the edit routine and the effect will be switched on. Rotor speed will be switched
automatically between Slow and Fast every 10 seconds.
2. Set the A-B switch on the back according to the setting you want to edit
3. The LO LED shows which parameter is selected. The following parameters can be edited:
Parameter Funktion Anzeige
SPEED
Adjusts slow and high speeds for the treble and
bass rotor
LO LED blinking 1x, then pause
BALANCE
Adjusts the volume relation between treble and
bass rotor
LO LED blinking 2x, then pause
DRIVE Amount of distortion (off,1,2,3,max) LO LED blinking 3x, then pause
DISTANCE
Adjusts the distance of the virtual mics to the
rotors
LO LED always blinking
MODE
Switches the Cabinet Simulation off/on
(GIT mode / KEY mode)
LO LED constantly on

Summary of content (4 pages)