Instruction Manual

5
8. Install axle - slide axle through hole in supports, then insert a cotter pin into the hole
on each end of the axle. The cotter pin must be on the inside of the support (reference
image shown).
9. Slide a spacer onto the axle shaft, then place a wheel on each end of the axle and fasten
with a 5/8-18 lock nut. DO NOT overtighten.
10. Position cart upright.
11. Assemble a handlebar bracket on each end of the handlebar. Fasten handle assembly
to base using the bolts and nuts provided.
12. Remove the popper’s old maid pan, then carefully install popper on cart - the power
cord goes down into the cabinet (a cord access hole is provided on the floor of the
cabinet). Make sure popper is securely seated on cart, then slide the old maid pan
through the cart opening and into the popper for use.
Note: If a spacer is used, make sure it is properly seated on top of the cart, then carefully
set the popper in place ensuring the feet set securely into the holes provided.
Handlebar
5/8-18 Lock Nut
Cotter Pin
(install on inside
of support)
Wheel Spacer
Base
Handlebar Bracket
Tie Plate
(attach to
axle
supports)
Leg Tie Strip
Leg Support
Bracket
1/4-20 x 3/4”
Hex HD Bolt
and Nut
Leg
Fasten axle bracket and
one end of leg support
to base as shown.
Fasten leg tie strip and one end
of leg support to base as shown.