Instruction Manual

4
INSTALLATION INSTRUCTIONS
Inspection of Shipment
After unpacking, check thoroughly for any damage which may have occurred in shipment.
Purchaser should make claim directly to carrier for any damages to merchandise that occur in
transit. The warranty does not cover damage that occurs in transit, or damage caused by abuse,
or consequential damage due to the operation of this machine, since it is beyond our control
(reference warranty in back of manual).
Manual
Read and understand the operator’s manual and all other safety instructions before using this
equipment. To order copies of the operator’s manual contact Global Solutions, 301 Meuse
Argonne Hicksville, OH 43526, 800.782.6761, or go to www.nemcofoodequip.com.
Items Included with this Unit
• Base Cabinet
• Handle Bar and 2 Handlebar Brackets
• 2 Wheels
• 1 Axle and 2 Axle Mount Brackets
• 2 Legs and 2 Leg Supports
• 1 Leg Tie Strip and 1 Tie Plate
• 2 Leg Caps
• Hardware Kit
Setup – Cart Assembly
This cart requires assembly. Remove all packaging and tape, then follow the steps below for cart
assembly (reference image shown on next page).
1. Turn base upside down.
2. Fasten legs to base cabinet using bolts and nuts provided.
Do not fully tighten any nuts until instructed (this will allow for slight adjustments
during installation).
3. Fasten the axle mount brackets to the cabinet base (flat side of brackets face outward).
FIRST fasten the bracket end above the wheel mount using a bolt and nut, THEN
fasten the other end of the axle bracket AND one end of a leg support to the base using
a bolt and nut, reference image shown.
4. Fasten opposite end of leg support AND a leg tie strip to each cart leg using a bolt and nut.
5. Bolt the tie plate to the axle supports.
6. Tighten all nuts securely at this time.
7. Install a leg cap on each leg end.