Specification Sheet

2
IF ROLLERS WON’T TURN
1. Check power source to be sure the roller grill is plugged into the proper voltage outlet and that the outlet
is in proper working order.
2. IMPORTANT: Disconnect the roller grill from the power source before disassembly.
3. Remove the end covers.
4. If the drive chain is off the idler sprocket, reinstall it.
5. Remove the drive chain from the sprocket on the motor shaft and if the rollers turn easily, then replace
the motor.
6. Remove the chain guard and inspect the sprockets on the end of each roller. If they are loose, worn, or
out of alignment, then replace the roller.
7. If the rollers are hard to turn by hand (without the chain attached) remove and clean out any
accumulated foreign matter in the bearings and on the rollers.
8. IMPORTANT: Reassemble the roller grill completely before reconnecting to the power source.
IF ROLLER GRILL BLOWS A FUSE OR CIRCUIT BREAKER
1. Check the capacity of the circuit being used to be sure it is not overloaded.
2. Unplug the roller grill and check it’s wiring for short circuits.
IF ROLLERS WON’T HEAT
Check the power source to be sure the roller grill is plugged into the proper voltage outlet and the receptacle
is working. If properly connected and still no heat call NEMCO customer service at 1-800-782-6761.
NEMCO FOOD EQUIPMENT 301 Meuse Argonne, Hicksville, OH 43526
Phone: [phone] Fax: [phone] Toll free: 1-800-782-6761
www.nemcofoodequip.com 9-27-13
48637