Specification Sheet

Nemco
®
Food Equipment, Ltd.
301 Meuse Argonne
Hicksville, Ohio 43526
1.800.782.6761
419.542.7751
419.542.6690, fax
www.nemcofoodequip.com
Stainless steel
under clamp model—
easily and securely affixes to
any counter up to 2
3
⁄4” thick.
Separate cutter
housing assembly—
When you purchase your
CanPRO, be sure to order
an extra, easy-to-replace
cutter housing assembly to
minimize downtime.
Can-locking feature
(holds up to #10 cans)—
easily orients and holds
the cutter to the lid.
Tough, lasting, precision-
ground stainless steel cutter—
cuts up to 5,000 lids, and is
easy to replace.
Making Your Countertop
More Profitable
Stainless steel permanent
mount model—screws into
the countertop. The security
model option (shown)
includes a locking capability.
(Lock not included.)
Smooth Operator
Model Description
56050-1 CanPRO Compact, Permanent
56050-2 CanPRO Compact, Under Clamp
56050-3 CanPRO Compact, Security Model
56022A Cutter Housing Assembly
56029 Cutter
Dimensions
Max. height 9
1
⁄2" (holds up to #10 can)
Handle radius 6"
Recommended handle turns per can size:
Can size Diameter Handle turns
#2 3" 3 revolutions
#5 5" 5 revolutions
#10 6" 6 revolutions
Note: Too many rotations—going beyond
the point of initial cut—may produce
metal slivers.
Replacement parts are available through
Nemco’s 24-hour Zip Program.
Say goodbye for good to the “lift, slam, puncture and rip” can-opening
techniques that have been overstressing elbows for 100 years. The NEW
redesigned CanPRO
®
Compact runs smarter and easier and longer than ever.
Think Outside the Can
Unlike conventional can openers that puncture and cut down into
the lid from the top, Nemco’s new CanPRO cuts from the side, along
the lid’s outer seam.
• The cutter never makes contact with the inside of the can.
• No metal shavings fall into the food.
• The lid comes off clean with no jagged edges.
Seams So Smooth
As a result of NEW engineering, the compression of the CanPRO’s
cutter has been carefully fine-tuned to improve performance.
• The cutter's new design won’t penetrate past the first layer of metal on
the lid’s seam, alleviating the potential for producing metal slivers if the
user overrotates the can.
• When the cutter runs its life cycle, it won’t cut at all, clearly
indicating it should be replaced.
Cut and Run…and Keep Running
The NEW CanPRO is specially designed to minimize downtime and costly
repairs.
Remove the cutter housing assembly and clean with a brush. Then simply
clean the rest of the unit in the dishwasher or your 3-compartment sink.
• No more gear breakage or wear, thanks to a completely gearless handle.
• The cutter housing is a quick-change module—
switch out a used for a new with just
a pull of a pin. Keep an extra new
modular cutter on hand, and you’re
never down.
• Stainless steel and aluminum nickel-
plated components translate into a long,
virtually maintenance-free life.
Printed 7/15. Printed in the U.S.A.