Instruction Manual

Appendix C: Ladder Diagram Block Reference Pointe Controller User Guide
408
C.7 String Blocks
C.7.1 Set string (SET)
When used in a Ladder Diagram, the SET block copies a string (variable or literal)
from an input to an output.
Select the tool (from the String Blocks toolbar) and click on a ladder rung to
insert the following block:
Once the block is inserted, you can double-click on it to configure it.
Functional Description
This block always passes the Enable input state (EN) through to the Enable Out
output state (ENO) without change; when EN becomes on, ENO is turned on, and
when EN becomes off, ENO is turned off.
When EN becomes on, the block function is executed: the Input String (IN) is
copied directly to the Output String (OUT).
The block function is executed every time the ladder is scanned, so long as EN
remains on. If EN becomes off, then OUT remains at its last calculated value until
EN becomes on and the block function is executed again.
Configuration Reference
The parameters of this block are described in the following table:
Param Name Config Var Type Description
EN Enable no - The state of the rung (off/on)
received from the left.
ENO Enable
Out
no - The state of the rung (off/on)
passed to the right.
IN Input
String
req String
Literal
The input string. Literals must be
enclosed in single quotes (‘ ’).
OUT Output
String
req String The result of copying the input
string. The output is always NULL-
terminated.