Instruction Manual

Appendix C: Ladder Diagram Block Reference Pointe Controller User Guide
372
Configuration Reference
The parameters of this block are described in the following table:
Param Name Config Var Type Description
EN Enable no - The state of the rung (off/on)
received from the left.
ENO Enable
Out
no - The state of the rung (off/on)
passed to the right.
IN Input
Value
req real only*
Numeric
The input value. If a Numeric value
is entered, it must be real /
floating.
OUT Output
Value
req real only* The result of calculating the arc
cosine of the input value, expressed
in radians.
* Any 32-bit Real (F) Input, Output, or Memory tag. For more information, see “Defining Input,
Output, Memory tags” on page 114.
C.3.12 Arc Tangent (ATAN)
When used in a Ladder Diagram, the ATAN block finds the arc tangent of an
input and sends the result to output.
Select the
tool (from the Math Blocks toolbar) and click on a ladder rung to
insert the following block:
Once the block is inserted, you can double-click on it to configure it.
Functional Description
This block always passes the Enable input state (EN) through to the Enable Out
output state (ENO) without change; when EN becomes on, ENO is turned on, and
when EN becomes off, ENO is turned off.
When EN becomes on, the block function is executed: the arc tangent of the
Input Value (IN) is calculated and the result is placed in the Output Value (OUT).
The result is expressed in radians.
The block function is executed every time the ladder is scanned, so long as EN
remains on. If EN becomes off, then OUT remains at its last calculated value until
EN becomes on and the block function is executed again.