Instruction Manual

Pointe Controller User Guide Appendix A: OptiLogic Technical Specifications
243
A.4 OL2111 AC Solid State Relay Module
The OL2111 AC Solid-state Relay Module provides eight (8)
solid-state relay outputs. This module is ideally suited for
switching small AC loads. As a solid-state device, switch
wear will not be a factor. Each output is optocoupled for
system isolation. Individual LED indicators provide visual
feedback indicating the state that each relay is being
driven.
Technical Specifications
Card Cage Power Required 120 mA
Output Type Solid state relay (Trice)
Outputs 8
Status Indicators Logic Side LED
Voltage Rating 12 – 132 VAC
Maximum load current 0.5 A / point @ 120VAC
Minimum load current 10 mA
On state voltage drop 1V (typical)
Peak surge current, 1 cycle 15 A
Commons 2 (connected internally)
Terminal Strip Plug In (removable)
Terminal Screws Slotted (0.1” blade max)
Max. terminal wire gauge 18 AWG (use copper conductors)
Terminal block torque 2.2 lb-in
Required Temp. rating of
field installed conductors
60°C / 75°C
Weight 1.3 oz (38 g)
Type 9
Subtype 3