Instruction Manual

Chapter 5: Developing Controller Programs Pointe Controller User Guide
128
5.5.3 Configuring operator panels
If you have specified an operator panel as being connected to your Pointe
Controller unit, you must configure its individual settings and I/O points to work
with your project. The configuration options are accessed by clicking on the I/O
button to the right of the panel.
NOTE: All of the tags for a given panel must already be defined in Logic Memory
before you can associate them with the panel’s I/O points. If the tags are not
defined or if you’re not sure what tags are required, review the panel below and
then go back to Defining Variables in Logic Memory.
Select an operator panel to configure:
MODULE GO TO…
OL3406 Pushbutton/Indicator Panel Page 284
OL3420 Operator Terminal Page 288
OL3440 Display Panel Page 291
OL3850 Keypad Terminal Page 292
For complete technical descriptions of all of these panels, see Appendix A,
“OptiLogic Technical Specifications.”
5.5.4 Configuring additional OptiLogic RTUs
You can configure up to four additional OptiLogic Remote Terminal Units (RTUs)
to work with your Pointe Controller unit. These units are slaved to your controller
using the OptiLogic UDP/IP communication protocol.
For more information, see Chapter 8, “Networked Operations,” starting on page
216.