User's Manual

Step 4: DIP switch positions marked 1 through 8 are used to set the message that will play

over the stores PA when the button is pressed. Use the Message DIP Switch Setting Chart

(pages 11 -12) to set the message. The unit comes preset with the switches set to trigger the

bilingual “Fragrance Case” message (see example below). Take notice of the “ON” direction

of the switch - ON is UP towards the “ON” marking on the switch and OFF is DOWN towards

the numbers on the switch. DIP switch 9 is not used.

Example of “Fragrance Case” message slot #75 setting & Channel set to “A”

Step 5: Insert the AAA battery into the cavity over the switch and secure down the door with

the screw using the long screwdriver.

Step 6: Press the button on the front of the button assembly to verify the correct message

plays. If message does not play refer to the troubleshooting section of this manual.

Press to Play Message

Step 7: Move to the next section of the manual for the appropriate mounting type: Shelf Mount

(page 6), Fragrance Case Mount (page 7 - 9) or Cabinet Mount (page 10).