User's Manual

Customer Service Button Initial Setup

Step 1: Remove the battery door from the rear of the button with the long screwdriver.

Step 2: A single battery should already be removed, if not remove the battery closest to the

hinge of the door. In the bottom of the battery cavity there will be a ten position DIP switch.

This switch is used to set the frequency channel number and message number to be triggered

when the button is pressed.

DIP Switch

Step 3: The DIP switch position marked 10 is used to set the buttons transmit frequency

channel. Verify this matches the stores receiver frequency channel. If receiver frequency is

unknown then start with Channel A since most stores are set this way.

Channel A - DIP #10 is set to OFF

Channel B - DIP #10 is set to ON