Operation Manual

3Chapter 1 . Get started
1. 3 Put in the cards
Insert Nano SIM cards and microSD card (optional)
1. Eject the SIM card tray by inserting the SIM ejector pin provided into the hole on the tray.
2. Place the the card(s) into the tray with the gold contacts face down. The card tray can support two Nano-
SIM cards and a mircoSD card.
3. Insert the card tray back into your phone in the correct orientation.
1. 4 Initial setup
It is recommended to insert your SIM card before you start the initial setup.
Press and hold the Power button to turn on your phone, and then follow the onscreen instructions to complete
the initial setup.
Note:
To avoid low battery power, your phone will shut down automatically if not operated on Initial setup screen in 30 minutes.
1. Select your language and location, and then tap .
2. Proceed to Connect to mobile network screen.
If you insert two SIM cards, follow the onscreen instructions to finish dual-SIM settings. You can always
adjust dual-SIM settings in
Settings -> Dual-SIM & network.
Your phone will automatically list available WLAN networks. Select the network you want to connect to (If
you want to view more Wi-Fi networks, tap See all Wi-Fi networks), and then enter the password to access
the Internet (This can take up to 2 minutes). If you have activated mobile data services with your carrier,
you can tap Use cellular network for setup. Or if you don’t want to connect to network, just tap SKIP ->
CONTINUE to skip this step.
Note:
Using cellular network for setup may result in additional fees. Contact your carrier for information about your cellular
data plan rates.
3. If you don’t connect to any networks, your device will proceed to Date & time screen. Set the data and
time, then tap NEXT. You also can tap NEXT directly to skip this step. You can always adjust date and time
in Settings -> More general settings -> Date & time.
4. Proceed to Name screen. Add your name to allow your phone to personalize some apps. Your name will be
saved as ME in
Contacts. Then tap NEXT after finishing. If you don’t want to set now, tap NEXT directly.
You can always set your name in Contacts -> Set up my profile.