Installation Instruction

Basic settings en
17
4.
Once the time has elapsed, the display shows the
time as zero. The appliance stops heating up and
responds again as usual outside of Sabbath mode.
‒ Switch off the appliance.
The appliance automatically switches off after ap-
prox.10to 20 minutes.
13 Basic settings
You can configure the appliance to meet your needs.
13.1 Overview of the basic settings
Here you can find an overview of the basic settings and factory settings. The basic settings depend on the features
of your appliance.
Display Basic setting Selection
Automatic childproof lock = no
1
= yes
Signal duration upon completion of a cook-
ing time or timer period
= 10 seconds
= 30 seconds
1
= 2 minutes
Waiting time until a setting is adopted = 3 seconds
1
= 6 seconds
= 10 seconds
Button tone when pressing a button = off
= on
1
Brightness of the display illumination = dark
= medium
1
= bright
Time display = hide the time
= display the time
1
Childproof lock can be adjusted = no
= yes
1
= yes, with locked door
Interior lighting during operation = no
= yes
1
Cooling fan run-on time = short
= medium
1
= long
= extra long
Telescopic shelves retrofitted
2, 3
= no
1
(for rails and 1-level pull-out)
= yes (for 2- and 3-level pull-out)
Sabbath mode available
3
= no
1
= yes
Reset all values to factory settings = no
1
= yes
.. HomeConnect Settings
→"HomeConnect ", Page18
1
Factory setting (may vary according to model)
2
Depending on the appliance specifications
3
Bottom oven
13.2 Changing basic settings
Requirement:The appliance is switched off.
1.
Press and hold the button for approximately
fourseconds.
a The first basic setting appears in the display,
e.g. ⁠ ⁠ ⁠ ⁠.
2.
Use the temperature selector to change the setting.
3.
Use the or button to switch to the next basic set-
ting.
4.
To save the changes, press and hold the button
for approx. fourseconds.
Note:Your changes to the basic settings will be re-
tained even after a power failure.
13.3 Discarding changes to the basic
settings
▶
Turn the function selector.
a All changes are discarded and not saved.