Instructions for Use

Trouble shooting en
43
3Trouble shooting
Tr oubl e shoot i ng Usually, faults are small matters that are easy to
eliminate. Please read the information in the table
before calling the after-sales service.
Display Possible cause Solution
None The power supply has been disconnected. Use other electrical appliances to check whether a short circuit
has occurred in the power supply.
The appliance has not been connected as shown
in the circuit diagram.
Make sure that the appliance has been connected as shown in
the circuit diagram.
Electronics fault. If the fault cannot be rectified, inform the technical after-sales ser-
vice.
The displays flash. The control panel is damp or there is something
on it.
Dry the control panel or remove the object.
The Ù indicator flashes in the
cooking zone displays.
A fault has occurred in the electronics. To acknowledge the fault, briefly cover the control panel with
your hand.
”ƒ/“ˆ‹‚†
The electronics have overheated and have
switched off the affected cooking zone.
Wait until the electronics have cooled down sufficiently. Then
touch any symbol on the control panel.
”…/“ˆ‹‚† /“‹ˆƒƒ/
“‹‰ƒƒ/ “‹Šƒƒ/
“‹ˆƒ„/“‹‰ƒ„/
“‹Šƒ„
The electronics have overheated and all of the
cooking zones have been switched off.
Ӡ + power level and audible
signal
There is hot cookware near the control panel.
There is a risk that the electronics will overheat.
Remove the cookware that is causing the problem. The fault dis-
play goes out shortly afterwards. The cooking process can be
continued.
Ӡ and audible signal
There is hot cookware near the control panel.
The cooking zone has been switched off to pro-
tect the electronics.
Remove the cookware that is causing the problem. Wait a few
seconds. Touch any touch control. When the fault display goes
out, you can resume cooking.
”‚/”‡
The cooking zone has overheated and has been
switched off to protect the work surface.
Wait until the electronics have cooled down sufficiently. Then
switch the cooking zone on again.
”‹
The transfer settings function cannot be acti-
vated.
Confirm the fault display by touching any sensor. You can cook as
usual without using the transfer settings function. Contact our
technical after-sales service.
”Š
The FlexPlus cooking zone cannot be activated. Confirm the fault display by touching any sensor. You can use the
other cooking zones to cook as usual. Contact our technical after-
sales service.
”‰
The cooking zone has been operating continu-
ously for an extended period.
The automatic safety cut-out function has been activated. See the
section entitled
“ˆ‹‚‹
The hob is unable to connect to your home net-
work or the extractor hood.
Confirm the fault display by touching any sensor. You can cook as
usual without a connection.
If the message appears again, contact our technical after-sales
service.
“Š‹‹‹
“Š‹‚‹
The operating voltage is incorrect and outside of
the normal operating range.
Contact your electricity supplier.
—…‹‹
The hob is not connected correctly. Disconnect the hob from the mains. Ensure that the hob has been
connected as shown in the circuit diagram.
š“
Demo mode is activated. Disconnect the hob from the mains. Wait for 30 seconds before
reconnecting it. Touch any sensor in the next three minutes.
Demo mode has now been deactivated.
Do not place hot cookware on the control panel.