T27DA69N0A Gas hob USER INSTRUCTIONS INSTALLATION INSTRUCTIONS MAINTENANCE INSTRUCTIONS This cooktop is approved for use with Natural Gas and Universal LPG. Leave these instructions with the owner.
en Table of contents NOITCURTSNI ] ne [ 8 Intended use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 ( Important safety information . . . . . . . . . . . . . . . 4 What to do if you smell gas . . . . . . . . . . . . . . . . . . . . . 4 5 Installation and connection. . . . . . . . . . . . . . . . . 5 Statutory requirements . . . . . . . . . . . . . . . . . . Preparing to install . . . . . . . . . . . . . . . . . . . . . Clearances . . . . . . . . . . . . . . . . . . . . . . . . . . .
Intended use 8Intended use Read these instructions carefully. You will only be able to use your appliance safely and effectively when you have read them. These operating and installation instructions should be retained, and passed onto the buyer if the appliance is sold. The manufacturer is exempt from all responsibility if the requirements of this manual are not complied with. The images shown in these instructions are for guidance only.
en Important safety information (Important safety information DO NOT MODIFY THIS APPLIANCE. DO NOT USE OR STORE FLAMMABLE MATERIALS IN THE APPLIANCE STORAGE DRAWER OR NEAR THE APPLIANCE. DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN OPERATION. DO NOT USE THIS APPLAINCE AS A SPACE HEATER. If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.
Installation and connection en 5Installation and connection Statutory requirements no i t c en o c dna no i t a l a t s n I This installation must conform with the following: ■ Manufacturer’s Installation instructions ■ Local Gas Fitting Regulations ■ Municipal Building Codes ■ Refer to AS/NZS 5601.1 for Gas Installations ■ S.A.A. Wiring Code ■ Local Electrical Regulations ■ Any other statutory regulations Preparing to install Refer to AS/NZS 5601.1 for piping size details.
en Installation and connection Clearances A range hood fitted above the top must be installed according to the installation instructions for the range hood. A minimum distance of 650 mm is required for a range hood and 750 mm for an exhaust fan. Any adjoining wall surface situated within 200 mm from the edge of any hob burner must be a suitable noncombustible material for a height of 150 mm for the entire length of the hob.
Installation and connection ■ When making this connection make sure that the lead cannot come into contact with hot parts of the cooktop. This appliance must be earthed. When connecting the cooktop ensure that the earth wire is connected first and that all wires are connected to the correct terminals. en Fit regulator (N.G.) or a test point (Universal LPG) directly to the R 1/2’’ connection. 9 9 a / 1 9 9 Direction of gas flow is indicated on the rear of the regulator.
en Installation and connection Before Leaving Check all connections for gas leaks with soap and water. DO NOT use a naked flame for detecting leaks. Ignite all burners both individually and concurrently to ensure correct operation of gas valves, burners and ignition. Turn gas taps to low flame position and observe stability of the flame for each burner individually and all together. Adhere the duplicate data plate to an accessible location near the hotplate.
Getting to know your appliance Adjusting the bypass If necessary, use a Torx screwdriver to adjust the bypass screws (M): A: For ULPG the bypass screws must be tightened properly. B: For Natural Gas the bypass screws must finish flush with the fitting.
en Getting to know your appliance For dual double-flame burners, the inner and outer flames can be controlled separately. The available power levels are as follows: k Inner and outer flame on full power. k kk k kk k k k k k k k Outer flame on low power, inner flame on full power. k kk k kk k k k k k k Inner flame on full power. k Residual heat indicator Every hotplate on the hob has a residual heat indicator that indicates whether it is hot or warm.
Gas burners ÄGas burners Switching on manually en If the burner flames are accidentally blown out, switch off the burner operating control knob and do not try to relight it for at least 1 minute. s renrub saG 1. Press the control knob for the selected burner and turn it anticlockwise to the highest power setting. 2. Hold an igniter or a naked flame (such as a lighter or a match) against the burner.
en Settings table and tips Pans should be placed on the hob carefully. Do not strike the hob and do not place excessive weight on it. Example: Do not place anything, eg. flame tamer, asbestos mat, between pan and pan support as serious damage to the appliance may result. Do not remove the pan support and enclose the burner with a wok stand as this will concentrate and deflect heat onto the hotplate. Do not use large pots or heavy weights which can bend the pan support or deflect flame onto the hotplate.
Settings table and tips Food Burner Standard-output burner Dual wok burner Rice High-output burner Standard-output burner Dual wok burner Ravioli High-output burner Standard-output burner Dual wok burner Total Step 1 Step 2 time in ˜ § v ˜ § v min.
en Settings table and tips Food Burner Total Step 1 time in ˜ § v min.
Cleaning and maintenance Food Burner Total Step 1 time in ˜ § v min.
en Trouble shooting Caution! The stainless steel cleaner must not be used in the area around the controls. The (printed) symbols may be wiped off. Do not leave acidic liquids (e.g. lemon juice, vinegar, etc.) on the hob. 3Trouble shooting DO NOT MODIFY THIS APPLIANCE. Only authorized personnel from the Service Centre are qualified to work on the appliance. gn i t o h s e l buo r T Fault Electrical operation is generally impaired. Sometimes certain faults detected can be easily resolved.
Customer service en 4Customer service When contacting our Technical Assistance Service, please provide the product number (E-Nr.) and production number (FD) of the appliance. This information is given on the specifications plate located on the lower section of the hob and on the label in the user manual. After-sales contact details for all countries can be found in the attached after-sales service directory.
&RQVWUXFWD 1HII 9HUWULHEV *PE+ &DUO :HU\ 6WUDH ' 0QFKHQ 5HJLVWHU \RXU SURGXFW RQOLQH ZZZ QHII LQWHUQDWLRQDO FRP *9001250924* 9001250924 970322(A) en
