T26DS59N0A Gas hob USER INSTRUCTIONS INSTALLATION INSTRUCTIONS MAINTENANCE INSTRUCTIONS This cooktop is approved for use with Natural Gas and Universal LPG. Leave these instructions with the owner.
en Table of contents NOITCURTSNI ] ne [ 8 Intended use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 ( Important safety information . . . . . . . . . . . . . . . 4 What to do if you smell gas . . . . . . . . . . . . . . . . . . . . . 4 5 Installation and connection. . . . . . . . . . . . . . . . . 5 Statutory requirements . . . . . . . . . . . . . . . . . . Preparing to install . . . . . . . . . . . . . . . . . . . . . Clearances . . . . . . . . . . . . . . . . . . . . . . . . . . .
Intended use 8Intended use Read these instructions carefully. You will only be able to use your appliance safely and effectively when you have read them. These operating and installation instructions should be retained, and passed onto the buyer if the appliance is sold. The manufacturer is exempt from all responsibility if the requirements of this manual are not complied with. The images shown in these instructions are for guidance only.
en Important safety information (Important safety information DO NOT MODIFY THIS APPLIANCE. DO NOT USE OR STORE FLAMMABLE MATERIALS IN THE APPLIANCE STORAGE DRAWER OR NEAR THE APPLIANCE. DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN OPERATION. DO NOT USE THIS APPLAINCE AS A SPACE HEATER. If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.
Installation and connection en 5Installation and connection Statutory requirements no i t c en o c dna no i t a l a t s n I This installation must conform with the following: ■ Manufacturer’s Installation instructions ■ Local Gas Fitting Regulations ■ Municipal Building Codes ■ Refer to AS/NZS 5601.1 for Gas Installations ■ S.A.A. Wiring Code ■ Local Electrical Regulations ■ Any other statutory regulations Preparing to install Refer to AS/NZS 5601.1 for piping size details.
en Installation and connection Clearances A range hood fitted above the top must be installed according to the installation instructions for the range hood. A minimum distance of 650 mm is required for a range hood and 750 mm for an exhaust fan. Any adjoining wall surface situated within 200 mm from the edge of any hob burner must be a suitable noncombustible material for a height of 150 mm for the entire length of the hob.
Installation and connection ■ When making this connection make sure that the lead cannot come into contact with hot parts of the cooktop. This appliance must be earthed. When connecting the cooktop ensure that the earth wire is connected first and that all wires are connected to the correct terminals. en Fit regulator (N.G.) or a test point (Universal LPG) directly to the R 1/2’’ connection. 9 9 a / 1 9 9 Direction of gas flow is indicated on the rear of the regulator.
en Installation and connection Before Leaving Check all connections for gas leaks with soap and water. DO NOT use a naked flame for detecting leaks. Ignite all burners both individually and concurrently to ensure correct operation of gas valves, burners and ignition. Turn gas taps to low flame position and observe stability of the flame for each burner individually and all together. Adhere the duplicate data plate to an accessible location near the hotplate.
Getting to know your appliance 3. If necessary, use a Torx screwdriver to adjust the bypass screws: A: For ULPG the bypass screws must be tightened properly. B: For Natural Gas the bypass screws must finish flush with the fitting. $ % en *Getting to know your appliance Burner locations ecna i l p a ruoy wonk o t gn i t eG 7 '6 1 $ 1 2 Make sure that the flame does not go out and that there are no flashbacks when you turn the control knob between the highest and lowest setting.
en Gas burners ÄGas burners Switching on manually s renrub saG 1. Press the control knob for the selected burner and turn it anticlockwise to the highest power setting. 2. Hold an igniter or a naked flame (such as a lighter or a match) against the burner. Automatic ignition If your appliance has automatic ignition (ignition plugs): 1. Press the control knob for the selected burner and turn it anticlockwise to the highest power setting.
Settings table and tips Pans should be placed on the hob carefully. Do not strike the hob and do not place excessive weight on it. If the burner flames are accidentally blown out, switch off the burner operating control knob and do not try to relight it for at least 1 minute. Do not place anything, eg. flame tamer, asbestos mat, between pan and pan support as serious damage to the appliance may result.
en Settings table and tips burner that was mentioned. The model overview describes all of the burners on the hob. Example: Food Burner Meal Burner Mini wok burner Ravioli Standard-output burner Mini wok burner Total time in min.
Settings table and tips Food Burner Spanish tortilla Mini wok burner Standard-output burner Total time in min.
en Cleaning and maintenance Food Burner Total time in min.
Trouble shooting en 3Trouble shooting DO NOT MODIFY THIS APPLIANCE. Only authorized personnel from the Service Centre are qualified to work on the appliance. gn i t o h s e l buo r T Fault The general electrical system is malfunctioning. The automatic switching on function does not work. The burner flame is not uniform. The gas flow is not normal or there is no gas. The kitchen smells of gas. Sometimes certain faults detected can be easily resolved.
&RQVWUXFWD 1HII 9HUWULHEV *PE+ &DUO :HU\ 6WUDH ' 0QFKHQ 5HJLVWHU \RXU SURGXFW RQOLQH ZZZ QHII LQWHUQDWLRQDO FRP *9001250416* 9001250416 970308(A) en
