User Manual

Operating the appliance aus
27
ExtraDry
The final rinse uses a higher
temperature which improves the drying
result (be careful if you have delicate
tableware). The running time may
increase slightly. You can switch the
function ExtraDry on š:‹‚ or off š:‹‹.
Auto Power Off (Automatic
switch off after end of
programme)
Au t o Powe r Off To save energy, the dishwasher is
switched off 1 minute after
the programme ends. You can also
change this setting.
Possible settings are:
■ ˜:‹‹: The dishwasher does not
switch off automatically.
■ ˜:‹‚: The dishwasher switches off
after 1 minute.
■ ˜:‹ƒ: The dishwasher switches off
after 2 hours.
Note: Note that with the settings ˜:‹‚
and ˜:‹ƒ the interior lighting 1" is
switched off. To activate the interior
lighting, press the ON/OFF switch (.
EmotionLight (Interior
lighting) *
Emot i onLi ght * depending on the configuration of
your specific dishwasher
EmotionLight 1" is the interior lighting
for your dishwasher. You can switch the
interior lighting on “:‹‚ or off “:‹‹.
Notes
■ Depending on the setting of
AutoPowerOff, the interior lighting is
either switched on or off.
■ Note that when the appliance is
switched on and the door is open,
the interior lighting will automatically
be switched off after 1 hour.
TimeLight (optical display
while a programme is
running) *
Ti meLi ght *Depending on the features of your
dishwasher
While a programme is running, an
optical display (additional programme
information) is projected onto the floor
at the bottom of the appliance door. If
the base panel is pulled forwards or if
the appliance is installed at eye-level
flush with the furniture then this display
will not be visible. You can switch the
optical display on †:‹‚ or off †:‹‹.
Infolight *
Infoli ght * depending on the configuration of
your specific dishwasher
While the programme is running, a light
spot shines on the floor under the
appliance door. Do not open the
appliance door until the light point is no
longer visible on the floor. If the
appliance door is not completely
closed, the light spot will flash *. If the
appliance is installed at eye-level, with
flush furniture front, the light point will
not be visible. You can switch the
Infolight on ‚:‹‚ or off ‚:‹‹.
Changing start programme *
Changi ng st ar t pr ogr amme * depending on the features of your
dishwasher
You can change the “Start programme”
setting.
Tone volume
The end of the programme is indicated
by an audible signal. You can adjust the
tone volume from †–:‹‹ - †–:‹„.If the
signal tone at the end of the programme
is annoying, set the value to †–:‹‹
(tone volume off).