User's Manual
Table Of Contents
- Double oven
- en
- Table of contents
- 1 Safety
- 2 Preventing material damage
- 3 Environmental protection and saving energy
- 4 Familiarising yourself with your appliance
- 5 Accessories
- 6 Before using for the first time
- 7 Basic operation
- 8 Time-setting options
- 9 Childproof lock
- 10 Rapid heating
- 11 Cleaning and servicing
- 12 Shelf supports
- 13 Appliance door
- 13.1 Detaching the lower appliance door
- 13.2 Attaching the lower appliance door
- 13.3 Removing the door panes from the lower the appliance door
- 13.4 Installing the door panes for the lower the appliance door
- 13.5 Detaching the upper appliance door
- 13.6 Attaching the upper appliance door
- 13.7 Removing the door panes from the upper the appliance door
- 13.8 Installing the door panes for the upper the appliance door
- 14 Troubleshooting
- 15 Disposal
- 16 Customer Service
- 17 How it works
- 18 Installation instructions
- 18.1 General installation instructions
- 18.2 Appliance dimensions
- 18.3 Installation below a worktop
- 18.4 Installation underneath a hob
- 18.5 Installation in a tall unit
- 18.6 Corner installation
- 18.7 Electrical connection
- 18.8 Installing the appliance in a tall unit
- 18.9 Installing the appliance under worktop
- 18.10 Removing the appliance
en Installation instructions
28
¡ Observe any available installation instructions for the
hob.
18.4 Installation underneath a hob
If the appliance is installed under a hob, the following
minimum dimensions must be adhered to (including
substructure, if applicable).
The minimum worktop thickness a is based on the
required minimum clearance .
Hob type a raised in mm a flush in mm b in mm
Induction hob 39 40 5
Full-surface induction hob 49 50 5
Gas hob 29 40 5
Electric hob 29 32 2
18.5 Installation in a tall unit
Observe the installation dimensions and the installation
instructions when installing in a tall unit.
¡ To ventilate the appliance, there must be a gap of
20mm between all intermediate floors and the wall.
¡ If the tall unit has another back panel in addition to
the element back panels, this must be removed.
¡ Only fit the appliance up to a height which allows
accessories to be easily removed.
¡ The mounting brackets are not required for installing
in a tall unit.
18.6 Corner installation
Observe the installation dimensions and the installation
instructions when installing in a corner.
¡ To ensure that the appliance door can be opened,
you must take the minimum dimensions into consid-
eration when installing in a corner. The dimension
is dependent on the thickness of the unit front and
the handle.