Instruction Manual

en Cleaning function
20
4. To switch off, turn the function selector to the "Off"
position.
5. Leave the appliance door ajar in the stop position
(approx. 30°) for approx. one hour to allow the
enamel surfaces in the cooking compartment to dry
thoroughly. Alternatively, you can also run the rapid
drying function for the cooking compartment.
Running the rapid drying function for the cooking
compartment
1. After the cleaning aid has been run through, leave
the appliance door ajar in the stop position (approx.
30°).
2. Start CircoTherm hot air with 50 °C.
3. After five minutes, switch off the appliance and close
the appliance door.
Removing heavy deposits of dirt
You have several options for removing particularly
stubborn deposits of dirt.
■ Leave the soapy water to work for some time before
starting the cleaning aid.
■ Rub soapy water onto the dirt on the smooth
surfaces before starting the cleaning aid.
■ Repeat the cleaning aid after the cooking
compartment has cooled down.
.Cleaning function
Cl e a n i n g functi on The self-cleaning surfaces in the cooking compartment
are cleaned with the "EcoClean" operating mode.
EcoClean
The self-cleaning surfaces (back panel, ceiling panel
and side panels) are coated with a porous, matt
ceramic material. This coating absorbs and breaks
down splashes from baking, roasting and grilling while
the oven is in operation. If the surfaces no longer clean
themselves adequately and dark patches appear, the
surfaces can be cleaned by the cleaning function.
Before running the cleaning function
Remove shelves, rails, accessories and ovenware from
the cooking compartment.
Cleaning the cooking compartment floor and the
inside of the appliance door
Remove the worst dirt from the cooking compartment
floor, the inside of the appliance door and the interior
lighting. Otherwise, patches will appear that can no
longer be removed.
Caution!
Do not use oven cleaner on the self-cleaning surfaces.
This will damage the surfaces. If oven cleaner does get
onto these surfaces, dab it off immediately using water
and a sponge cloth. Do not rub the surface and do not
use abrasive cleaning aids.
:Warning – Risk of burns!
; The appliance becomes very hot on the outside
during the cleaning function. Never touch the appliance
door. Allow the appliance to cool down. Keep children
at a safe distance.
Setting the cleaning function
Make sure you follow all the preparation instructions
before setting the cleaning function.
1. Use the function selector to set EcoClean ™.
2. Use the temperature selector to set EcoClean ™.
3. Switch off the appliance after 60 minutes.
Note: You can also set the timer to remind you after
60 minutes.
Ventilate the kitchen while the cleaning function is
running.
Once the cleaning function has finished
Once the cooking compartment has cooled down, wipe
down the cooking compartment with a damp cloth if
necessary.
Note: During operation and while the cleaning function
is active, reddish patches may form on the surfaces.
This is not rust, but residue from food. These spots are
not harmful and do not impair the cleaning ability of the
self-cleaning surfaces.